PLA Silk

Beginner

Polylactic Acid with Elastomer or Polyester Additives

Modified PLA with optical additives producing a high-gloss metallic sheen without post-processing. Ideal for decorative, aesthetic prints.

⚠ IMPORTANT: Dry Your Filament Before Every Print

All filaments — including PLA Silk — absorb moisture from the air. Printing with wet filament causes stringing, bubbling, weak layer adhesion, and poor surface finish. This is the single most overlooked cause of bad prints.

Always dry your filament per the manufacturer's recommendations printed on the spool label before printing, especially if the spool has been open for more than a few days or stored in a humid environment. Read our complete filament drying guide →

About the Temperatures & Speeds Listed Below

The print temperatures and speeds shown on this page are general industry ranges — not a one-size-fits-all prescription. Every printer brand and model has different capabilities. A Bambu Lab X1C can print PLA at 500 mm/s; an Ender 3 with a Bowden extruder performs best at 40–80 mm/s.

Always follow your specific printer manufacturer's recommended settings and the temperature range printed on your filament spool label. Start at the lower end of the range and dial in from there.

Material Properties

Strength4/10

Flexibility2/10

Heat Resistance3/10

Printability8/10

PLA Silk is part of the PLA family. See the complete PLA guide →

Best For

Decorative vases
busts
figurines
cosplay props
display models
gift items

Avoid For

High-temperature environments

Pro Tips

01Increase nozzle temp by 5°C increments; slow print speed to 40-50mm/s
02Increase nozzle temperature; reduce cooling fan on first few layers
03Dry filament; tune retraction; enable combing in slicer

Print Speed by Printer Tier

Print speeds vary dramatically by printer. The speeds listed in product specs (like "500 mm/s") are maximum capabilities — not recommended everyday speeds. Use this table as a general guide and always follow your printer manufacturer's recommended settings.

High-End (Bambu X1C, P2S, H2D)

Print Speed: 150–300 mm/s

High-acceleration direct-drive systems. Follow manufacturer slicer presets.

Mid-Range (Bambu A1/A1 Mini, Prusa MK4, Creality K1)

Print Speed: 60–150 mm/s

Good performance at moderate speeds. Follow slicer presets for best results.

Entry-Level (Ender 3 series, Bowden extruders)

Print Speed: 30–60 mm/s

Start slow and tune up. Follow your printer manufacturer's recommended settings.

Quick Specs

Print Temp210–230°C

Bed Temp45–60°C

Cost / kg$20–$30

EnclosureNot Required

DryingRequired

DifficultyBeginner

Drying Note: Even filaments marked "Not Required" benefit from drying if the spool has been open or stored in a humid area. When in doubt, dry it.

Buy PLA Silk Filament

Recommended brands: Hatchbox, eSUN, Polymaker, Bambu

Shop on Amazon

Affiliate link — helps support FilamentMap

Other Filaments