ASA-CF

Advanced

Acrylonitrile Styrene Acrylate with Chopped Carbon Fiber

ASA reinforced with chopped carbon fiber. Combines exceptional UV resistance and weatherability with high stiffness. The best choice for outdoor structural parts.

⚠ IMPORTANT: Dry Your Filament Before Every Print

All filaments — including ASA-CF — absorb moisture from the air. Printing with wet filament causes stringing, bubbling, weak layer adhesion, and poor surface finish. This is the single most overlooked cause of bad prints.

Always dry your filament per the manufacturer's recommendations printed on the spool label before printing, especially if the spool has been open for more than a few days or stored in a humid environment. Read our complete filament drying guide →

About the Temperatures & Speeds Listed Below

The print temperatures and speeds shown on this page are general industry ranges — not a one-size-fits-all prescription. Every printer brand and model has different capabilities. A Bambu Lab X1C can print PLA at 500 mm/s; an Ender 3 with a Bowden extruder performs best at 40–80 mm/s.

Always follow your specific printer manufacturer's recommended settings and the temperature range printed on your filament spool label. Start at the lower end of the range and dial in from there.

Material Properties

Strength8/10

Flexibility2/10

Heat Resistance8/10

Printability6/10

ASA-CF is part of the ASA family. See the complete ASA guide →

Best For

Outdoor functional parts
automotive exterior components
fixtures exposed to sunlight and weather

Avoid For

Open-air printing without an enclosure

Pro Tips

01Print in heated enclosure; layer splitting is the primary failure mode without enclosure
02Hardened steel nozzle is mandatory
03More brittle than standard ASA; use generous wall thickness and rounded corners

Print Speed by Printer Tier

Print speeds vary dramatically by printer. The speeds listed in product specs (like "500 mm/s") are maximum capabilities — not recommended everyday speeds. Use this table as a general guide and always follow your printer manufacturer's recommended settings.

High-End (Bambu X1C, P2S, H2D)

Print Speed: 150–300 mm/s

High-acceleration direct-drive systems. Follow manufacturer slicer presets.

Mid-Range (Bambu A1/A1 Mini, Prusa MK4, Creality K1)

Print Speed: 60–150 mm/s

Good performance at moderate speeds. Follow slicer presets for best results.

Entry-Level (Ender 3 series, Bowden extruders)

Print Speed: 30–60 mm/s

Start slow and tune up. Follow your printer manufacturer's recommended settings.

Quick Specs

Print Temp240–270°C

Bed Temp90–110°C

Cost / kg$45–$65

EnclosureRequired

DryingRequired

DifficultyAdvanced

Drying Note: Even filaments marked "Not Required" benefit from drying if the spool has been open or stored in a humid area. When in doubt, dry it.

Buy ASA-CF Filament

Recommended brands: Hatchbox, eSUN, Polymaker, Bambu

Shop on Amazon

Affiliate link — helps support FilamentMap

Other Filaments